VERSA LINER® Production Process

The VERSA LINER® Production Process is a simple method that makes for fast set up and easy
clean up. For complete details on how to install VERSA LINER® in a form, please refer to the
MBrick™ Technical Design and Installation Guide, which can be found in the Downloads section.

The following is intended to provide a general overview of installation.

Step 1: Trim liner sheets as necessary prior to installation into the form.

Step 2: Mark the side of the form every 2 feet for exact coursing control purposes.

Step 3: Begin placing liner sheets in the form in accordance with the shop drawings. Note: The plus (+) edge joint secures over the minus (-) edge joint on the adjoining sheet. Place only one tier of sheets prior to placing the bricks, face down, in to the liner. Watch your coursing as you progress.

Step 4: Once fully bricked, check panel to ensure all bricks are fully nested and flat in the liner.

Step 5: Install reinforcement and proceed with the pour.

Step 6: Cleanup: Remove sheets by merely peeling them off the cured panel. Spray panel with a hot water pressure washer to remove concrete film.